- Notes, cautions, and warnings
- Working on your computer
- Stands
- Removing and installing components
- Recommended tools
- Screw List
- Major components of your system
- Hard-drive assembly
- Hard-drive bracket
- Hard drive
- Solid-state drive in the hard-drive bay
- Solid-state drive daughter board
- Cover
- Memory module
- WLAN card
- Internal solid-state drive
- eMMC Storage module
- System fan
- Power button
- Coin-cell battery
- System board
- Heat-sink
- Replacing the chassis
- Software
- System setup
- Troubleshooting
- Getting help and contacting Dell
OptiPlex 7090 Ultra Service Manual
Installing the cover
Prerequisites
About this task
The figure indicates the location of the cover and provides a visual representation of the installation procedure.
Steps
- Align the tabs on the cover with the slots on the chassis.
- Slide the cover until it clicks into place.
Next steps
- Install the device on Fixed stand/Pro 1 height-adjustable stand/Offset VESA mount/Pro 2 height-adjustable stand/Wall mount.
- Follow the procedure in after working on your device.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\