- Notes, cautions, and warnings
- Working on your computer
- Stands
- Removing and installing components
- Recommended tools
- Screw List
- Major components of your system
- Hard-drive assembly
- Hard-drive bracket
- Hard drive
- Solid-state drive in the hard-drive bay
- Solid-state drive daughter board
- Cover
- Memory module
- WLAN card
- Internal solid-state drive
- eMMC Storage module
- System fan
- Power button
- Coin-cell battery
- System board
- Heat-sink
- Replacing the chassis
- Software
- System setup
- Troubleshooting
- Getting help and contacting Dell
OptiPlex 7090 Ultra Service Manual
Installing the eMMC storage module
Prerequisites
About this task
The figure indicates the location of the eMMC storage module and provides a visual representation of the installation procedure.
Steps
- Align the notch on the eMMC storage module with the connector on the system board and slide the eMMC storage module at an angle into the slot.
- Replace the (M2x3.5) screw to secure the eMMC storage module to the system board.
Next steps
- Install the cover.
- Install the device on Fixed stand/Pro 1 height-adjustable stand/Offset VESA mount/Pro 2 height-adjustable stand/Wall mount.
- Follow the procedure in after working on your device.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\