- Notes, cautions, and warnings
- Working on your computer
- Stands
- Removing and installing components
- Recommended tools
- Screw List
- Major components of your system
- Hard-drive assembly
- Hard-drive bracket
- Hard drive
- Solid-state drive in the hard-drive bay
- Solid-state drive daughter board
- Cover
- Memory module
- WLAN card
- Internal solid-state drive
- eMMC Storage module
- System fan
- Power button
- Coin-cell battery
- System board
- Heat-sink
- Replacing the chassis
- Software
- System setup
- Troubleshooting
- Getting help and contacting Dell
OptiPlex 7090 Ultra Service Manual
Removing the WLAN card
Prerequisites
- Follow the procedure in before working inside your device.
- Remove the device from fixed stand/Pro 1 height-adjustable stand/Offset VESA mount/Pro 2 height-adjustable stand/Wall mount.
- Remove the cover.
About this task
The figure indicates the location of the WLAN card and provides a visual representation of the removal procedure.
Steps
- Remove the (M2x3.5) screw that secures the WLAN bracket to the system board.
- Slide and lift the WLAN bracket.
- Disconnect the WLAN antenna cables from the WLAN card.
- Lift and slide the WLAN card from the WLAN connector on the system board.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\