OptiPlex 7090 Ultra Service Manual

Installing the device on a fixed stand

1. Align and insert the slots on the fixed stand into the tab on the stand base.
2. Lift and tilt the stand base.
3. Tighten the captive screw to secure the stand to the base.
   
4. Slide the release latch on the stand, until you hear a click, to release the stand cover.
5. Slide and lift the cover to release it from the stand.
   
6. Remove the screw that secures the stand mounting bracket to the stand.
7. Lift the mounting bracket to release the hooks on the bracket from the slots on the stand.
   
8. To avoid any damage to the monitor, ensure that you place the monitor on a protective sheet.
9. Align the screws on the mounting bracket with the screw holes on the monitor.
10. Tighten the four captive screws to secure the mounting bracket to the monitor.
    
11. Select the height at which you want to mount the monitor and align the hooks on the mounting bracket with the slots on the stand.
12. Replace the screw to secure the fixed stand to the monitor.
    
13. Align the vents on the device with the vents on the stand cover.
14. Lower the device in the stand until you hear a click.
    
15. Connect the power, network, keyboard, mouse, and display cables to the device and to the power outlet.
    NOTE To avoid any pinching or crimping of the cables while closing the stand cover, it is recommended that you route the cables as indicated in the image.

    NOTE All the cables and ports are used depending on the peripherals chosen and the configuration of the computer.
    
16. Slide the back cover, along with the device, into the stand until you hear a click.
    
17. Lock the device and the stand cover.
    
18. Press the power button to turn on the device.