OptiPlex 7090 Ultra Service Manual

Installing the hard-drive assembly

If you are replacing a component, remove the existing component before performing the installation procedure.

The figure indicates the location of the hard-drive assembly module and provides a visual representation of the installation procedure.

This image shows the installation of hard-drive assembly

Place the hard-drive assembly on the cover.
Route the hard-drive cable through the routing guide on the chassis.
Connect the hard-drive cable to the connector on the system board and close the latch to secure the cable.
Turn the hard-drive assembly module and align the tabs on the hard-drive assembly with the slots on the chassis.
Align the screw hole on the hard-drive assembly with the screw hole on the chassis.
Replace the M2x3 screw to secure the hard-drive assembly to the chassis.