- Notes, cautions, and warnings
- Working on your computer
- Stands
- Removing and installing components
- Recommended tools
- Screw List
- Major components of your system
- Hard-drive assembly
- Hard-drive bracket
- Hard drive
- Solid-state drive in the hard-drive bay
- Solid-state drive daughter board
- Cover
- Memory module
- WLAN card
- Internal solid-state drive
- eMMC Storage module
- System fan
- Power button
- Coin-cell battery
- System board
- Heat-sink
- Replacing the chassis
- Software
- System setup
- Troubleshooting
- Getting help and contacting Dell
OptiPlex 7090 Ultra Service Manual
Installing the hard drive
Prerequisites
About this task
The figure indicates the location of the hard-drive module and provides a visual representation of the installation procedure.
Steps
- Insert the hard drive into the protective sleeve.
NOTE Ensure to match the mark on the protective sleeve with the hard drive PIN and connector location.
- Pull the protective sleeves along the hard-drive edges.
- Connect the hard-drive cable to the connector on the hard drive.
Next steps
- Install the hard-drive bracket.
- Install the hard-drive assembly.
- Install the device on Fixed stand/Pro 1 height-adjustable stand/Offset VESA mount/Pro 2 height-adjustable stand/Wall mount.
- Follow the procedure in after working on your device.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\