Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

OptiPlex 7090 Ultra Service Manual

PDF

Installing the heat-sink

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The figure indicates the location of the heat-sink and provides a visual representation of the installation procedure.

Installing the heat-sink

Steps

  1. Align the screws on the heat-sink with the screw holes on the system board.
  2. In sequential order (as indicated on the heat sink), tighten the four captive screws that secure the heat sink to the system board.

Next steps

  1. Install the system board.
  2. Install the solid-state drive
  3. Install the memory module.
  4. Install the WLAN card.
  5. Install the system fan.
  6. Install the cover.
  7. Install the hard-drive assembly.
    NOTE For systems configured with solid-state drive in the hard-drive bay
  8. Install the device on Fixed stand/Pro 1 height-adjustable stand/Offset VESA mount/Pro 2 height-adjustable stand/Wall mount.
  9. Follow the procedure in after working on your device.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\