OptiPlex 7090 Ultra Service Manual

Installing the device on a Pro 1 height-adjustable stand

1. Align and insert the slots on the height-adjustable stand into the tab on the stand base.
2. Lift and tilt the stand base.
3. Tighten the captive screw to secure the stand to the base.
   
4. To avoid any damage to the monitor, ensure that you place the monitor on a protective sheet.
5. For installing the height-adjustable stand to the monitor:
   1. Align and insert the hooks on the mounting bracket on the stand into the slots on the monitor, until you hear a click.
      
6. For installing QR to VESA bracket for E-Series monitor or monitor without Quick Release support:
   1. Align the screw holes on the QR to VESA bracket with the screw holes on the monitor.
   2. Install the four screw spacers and the screws to secure the QR to VESA bracket to the monitor.
   3. Align and insert the QR tabs on the stand into the slots on the QR to VESA bracket on the monitor.
   4. Tighten the thumb screw to secure the stand to the QR to VESA bracket.
      
7. To release the stand cover, slide the release latch until you hear a click.
8. Slide and lift the cover to release it from the stand.
9. Align the vents on the device with the vents on the stand cover.
10. Lower the device in the stand until you hear a click.
    
11. Connect the power, network, keyboard, mouse, and display cables to the device and to the power outlet.
    NOTE To avoid any pinching or crimping of the cables while closing the stand cover, it is recommended that you route the cables as indicated in the image.

    NOTE All the cables and ports are used depending on the peripherals chosen and the configuration of the computer.
    
12. Slide the back cover, along with the device, into the stand until you hear a click.
    
13. Lock the device and the stand cover.
    
14. Press the power button to turn on the device.