Dell EMC Solutions Enabler 9.2 SRDF Family CLI User Guide

Syntax

Use the symrdf set rdfg command to set the attributes for an SRDF group.

symrdf -sid SID -rdfg GrpNum|-label GrpLabel [-v] [-symforce]
	[-noprompt] [-i Interval] [-c Count]
.............
	set rdfg
		[-limbo {0 - 120}]                                      
		[-domino {on|off}]                           
		[-autolink_recovery {on|off}]
		[-hwcomp {on|off}]
		[-swcomp {on|off}]
		[-both_sides]

Options

-both_sides

Applies the group attribute to both the source and target sides of an SRDF session. If this option is not specified, attributes are only applied to the source side.

-limbo {0 - 120}

Sets the duration of the link limbo timer (seeLink limbo).

-domino {on|off}

Switches domino mode on or off (see Domino mode). This option is not allowed for VASA SRDF groups.

-autolink_recovery {on|off}

Switches autolink recovery on or off (see Autolink recovery). This option is not allowed for VASA SRDF groups.

-hwcomp {on|off}]

Switches hardware compression on or off (see Hardware compression).

-swcomp {on|off}

Switches software compression on or off (see Software compression).

Examples

To set the link limbo value to one minute (60 seconds) for both sides of SRDF group 4 on array 6180:

symrdf -sid 6180 -rdfg 4 set rdfg -limbo 60 -both_sides

To set the Link Domino mode on both sides of group 4 on array 6180:

symrdf -sid 6180 -rdfg 4 set rdfg -domino on -both_sides

To set the Autolink Recovery mode on both sides of group 4 on array 6180:

symrdf -sid 6180 -rdfg 4 set rdfg -autolink_recovery on -both_sides

To set limbo to thirty seconds and turn off Link Domino and Autolink Recovery modes for SRDF group 12:

symrdf -sid 134 -rdfg 12 set rdfg -limbo 30 -domino off -autolink_recovery off

To turn on software compression and turn off hardware compression on both sides of the SRDF group 12:

symrdf -sid 134 -rdfg 12 set rdfg -swcomp on -hwc off -both_sides