Zu den Hauptinhalten
  • Bestellungen schnell und einfach aufgeben
  • Bestellungen anzeigen und den Versandstatus verfolgen
  • Profitieren Sie von exklusiven Prämien und Rabatten für Mitglieder
  • Erstellen Sie eine Liste Ihrer Produkte, auf die Sie jederzeit zugreifen können.
  • Verwalten Sie mit der Unternehmensverwaltung Ihre Dell EMC Seiten, Produkte und produktspezifischen Kontakte.

Dell PowerEdge R230 Owner's Manual

Installing a memory module

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.
  3. Remove the cooling shroud.

NOTE: : The memory modules are hot to touch for some time after the system has been powered down. Allow the memory modules to cool before handling them. Handle the memory modules by the card edges and avoid touching the components or metallic contacts on the memory module.

Steps

  1. Locate the appropriate memory module socket.

    CAUTION: : Handle each memory module only by the card edges, ensuring not to touch the middle of the memory module or metallic contacts.

    CAUTION: : To prevent damage to the memory module or the memory module socket during installation, do not bend or flex the memory module; insert both ends of the memory module simultaneously.

  2. Align the edge connector of the memory module with the alignment key of the memory module socket, and insert the memory module in the socket.

    NOTE: : The memory module socket has an alignment key that enables you to install the memory module in the socket in only one orientation.

    CAUTION: : Do not apply pressure at the center of the memory module; apply pressure at both ends of the memory module evenly.

  3. Press the memory module with your thumbs until the socket levers firmly click into place.

    When the memory module is properly seated in the socket, the levers on the memory module socket align with the levers on the other sockets that have memory modules installed.

    Figure 1. Installing the memory module
    This figure shows installing the memory module.
    1. memory module
    2. alignment key
    3. memory module socket ejector (2)

Next steps

  1. Install the cooling shroud.
  2. Follow the procedure listed in the After working inside your system section.
  3. To enter System Setup, press F2 and check the System Memory setting.

    The System Memory Size indicates the installed memory.

  4. If the System Memory Size is incorrect, one or more of the memory modules may not be installed properly. Ensure that the memory modules are firmly seated in their sockets.
  5. Run the system memory test in the system diagnostics.

Diesen Inhalt bewerten

Präzise
Nützlich
Leicht verständlich
War dieser Artikel hilfreich?
0/3000 characters
  Bitte geben Sie eine Bewertung ab (1 bis 5 Sterne).
  Bitte geben Sie eine Bewertung ab (1 bis 5 Sterne).
  Bitte geben Sie eine Bewertung ab (1 bis 5 Sterne).
  Bitte geben Sie an, ob der Artikel hilfreich war.
  Die folgenden Sonderzeichen dürfen in Kommentaren nicht verwendet werden: <>()\