Dell PowerEdge R230 Owner's Manual

Removing the LCD control panel assembly

Prerequisites

CAUTION: : Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

Follow the safety guidelines listed in safety instructions section.
Follow the procedure listed in the Before working inside your system section.
Keep the Phillips #2 screwdriver ready.

Steps

Disconnect the cables from the control panel board.
CAUTION: : Do not use excessive force when removing the control panel as it can damage the connectors.
Hold the top edge of the LCD control panel at the corners and pull upward until the LCD control panel tabs are released.
Pull the control panel away from the chassis.
Remove the screws securing the LCD control panel board.
Lift the LCD control panel board away from the chassis.
Figure 1. Removing the LCD control panel—four 3.5-inch hot swappable hard drive chassis
1. LCD control panel
2. notches (6)
3. display module cable retention clip
4. display module cable
5. tabs on the LCD control panel (6)
Figure 2. Removing the LCD control panel board—four hard drive chassis
1. screw (2)
2. control panel connector cable
3. display module cable
4. LCD control panel board
5. USB connector cable
6. standoff on the chassis (2)

Next steps

Install the LCD control panel assembly.
Follow the procedure listed in the After working inside your system section.

Willkommen

Willkommen bei Dell

Dell PowerEdge R230 Owner's Manual

Removing the LCD control panel assembly

Prerequisites

Steps

Next steps

Diesen Inhalt bewerten