Zu den Hauptinhalten
Abmelden

Willkommen bei Dell

Mein Konto
  • Bestellungen schnell und einfach aufgeben
  • Bestellungen anzeigen und den Versandstatus verfolgen
  • Profitieren Sie von exklusiven Prämien und Rabatten für Mitglieder
  • Erstellen Sie eine Liste Ihrer Produkte, auf die Sie jederzeit zugreifen können.
  • Verwalten Sie mit der Unternehmensverwaltung Ihre Dell EMC Seiten, Produkte und produktspezifischen Kontakte.
Anmelden Konto erstellen Premier-Anmeldung Anmeldung beim Partnerprogramm
Kontakt

Ihr Warenkorb bei Dell.com

Dell PowerEdge R230 Owner's Manual

PDF

Installing the heat sink

Prerequisites

CAUTION: : Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

NOTE: : This is a Field Replaceable Unit (FRU). Removal and installation procedures should be performed only by Dell certified service technicians.

  1. Ensure that you follow the Safety instructions.
  2. Keep the Phillips #2 screwdriver ready.
  3. Follow the procedure listed in Before working inside your system.
  4. Remove the cooling shroud.
  5. Install the processor.

Steps

  1. If you are using an existing heat sink, remove the thermal grease from the heat sink by using a clean lint free cloth.
  2. Use the thermal grease syringe included with your processor kit to apply the grease in a thin spiral on the top of the processor as shown in the following figure.

    CAUTION: : Applying too much thermal grease can result in excess grease coming in contact with and contaminating the processor socket.

    NOTE: : The thermal grease syringe is intended for one-time use only. Dispose of the syringe after you use it.

    Figure 1. Applying thermal grease on the top of the processor
    This figure shows applying thermal grease on the top of the processor.
    1. processor
    2. thermal grease
    3. thermal grease syringe
  3. Place the heat sink onto the processor.

    NOTE: : Ensure that the arrow on the heat sink is facing the back of the chassis.

  4. Tighten one of the four screws to secure the heat sink to the system board.
  5. Tighten the screw diagonally opposite to the first screw you tightened.

    NOTE: : Do not overtighten the heat sink retention screws when installing the heat sink. To prevent overtightening, tighten the retention screw until resistance is felt. The screw tension must not be more than 6 in-lb (6.9 kg-cm).

  6. Repeat the procedure for the remaining two screws.

Next steps

  1. Install the cooling shroud.
  2. Follow the procedure listed in After working inside your system.
  3. While booting, press F2 to enter System Setup and check that the processor information matches the new system configuration.
  4. Run the system diagnostics to verify that the new processor operates correctly.

Diesen Inhalt bewerten

Präzise
Nützlich
Leicht verständlich
War dieser Artikel hilfreich?
0/3000 characters
  Bitte geben Sie eine Bewertung ab (1 bis 5 Sterne).
  Bitte geben Sie eine Bewertung ab (1 bis 5 Sterne).
  Bitte geben Sie eine Bewertung ab (1 bis 5 Sterne).
  Bitte geben Sie an, ob der Artikel hilfreich war.
  Die folgenden Sonderzeichen dürfen in Kommentaren nicht verwendet werden: <>()\