PowerScaleOneFS CLI Command Reference

The command will not succeed until SyncIQ can communicate with the target cluster; until then, the policy will still appear in the output of the isi sync policies list command. After the connection between the source cluster and target cluster is reestablished, SyncIQ will delete the policy the next time that the job is scheduled to run; if the policy is configured to run only manually, you must manually run the policy again. If SyncIQ is permanently unable to communicate with the target cluster, specify the --local-only option. This will delete the policy from the local cluster only and not break the target association on the target cluster.

Syntax

isi sync policies delete {<policy> | --all}   
  [--local-only] 
  [--force]
  [--verbose]

Options

<policy>

Deletes the specified replication policy.

--all

Deletes all replication policies.

--local-only

Does not break the target association on the target cluster. Not deleting a policy association on the target cluster will cause the target directory to remain in a read-only state.

NOTE:If SyncIQ is unable to communicate with the target cluster, you must specify this option to successfully delete the policy.

{--force | -f}

Deletes the policy, even if an associated job is currently running. Also, does not prompt you to confirm the deletion.

CAUTION: Forcing a policy to delete might cause errors if an associated replication job is currently running.

{--verbose | -v}

Displays a confirmation message.