OptiPlex Small Form Factor 7010 Owner's Manual

Installing the processor

CAUTION:The information in this section is intended for authorized service technicians only.

If you are replacing a component, remove the existing component before performing the installation procedure.

The following image indicates the location of the processor and provides a visual representation of the installation procedure.

Installing the processor

Ensure that the release lever on the processor socket is fully extended in the open position.
NOTE: The pin-1 corner of the processor has a triangle that aligns with the triangle on the pin-1 corner on the processor socket. When the processor is properly seated, all four corners are aligned at the same height. If one or more corners of the processor are higher than the others, the processor is not seated properly.
Align the notches on the processor with the tabs on the processor socket and place the processor in the processor socket.
CAUTION: Ensure that the processor-cover notch is positioned underneath the alignment post.
When the processor is fully seated in the socket, pivot the release-lever down and place it under the tab on the processor cover.