Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

OptiPlex Small Form Factor 7010 Owner's Manual

PDF

Removing the power-supply unit

CAUTION:The information in this section is intended for authorized service technicians only.

Prerequisites

  1. Follow the procedure in Before working inside your computer.
  2. Remove the side cover.
  3. Remove the front bezel.
  4. Remove the 2.5-inch hard drive if applicable.
  5. Remove the 3.5-inch hard drive if applicable.
  6. Remove the disk-drive cage.

About this task

The following image indicates the location of the power-supply unit and provides a visual representation of the removal procedure.

Removing the power-supply unitRemoving the power-supply unit

Steps

  1. Disconnect the power-supply cables from their connectors on the system board.
  2. Un-route the power-supply cables from the routing guides on the chassis.
  3. Remove the three screws (M6-32) that secure the power-supply unit to the chassis.
  4. Slide and lift the power-supply unit off the chassis.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\