- Notes, cautions, and warnings
- Views of OptiPlex Small Form Factor 7010
- Set up your computer
- Specifications of OptiPlex Small Form Factor 7010
- Dimensions and weight
- Processor
- Chipset
- Operating system
- Memory
- External ports
- Internal slots
- Ethernet
- Wireless module
- Audio
- Storage
- Power ratings
- GPU—Integrated
- External display support (GPU—Integrated)
- GPU—Discrete
- External display support (GPU—Discrete)
- Hardware security
- Environmental
- Regulatory compliance
- Operating and storage environment
- Working inside your computer
- Removing and installing side cover
- Removing and installing coin-cell battery
- Removing and installing Customer Replaceable Units (CRUs)
- Removing and installing Field Replaceable Units (FRUs)
- Software
- BIOS Setup
- Troubleshooting
- Getting help and contacting Dell
OptiPlex Small Form Factor 7010 Owner's Manual
Removing the optical drive
Prerequisites
- Follow the procedure in Before working inside your computer.
- Remove the side cover.
- Remove the front bezel.
- Remove the 2.5-inch hard drive if applicable.
- Remove the 3.5-inch hard drive if applicable.
- Remove the disk-drive cage.
About this task
The following image indicates the location of the optical-drive assembly and provides a visual representation of the removal procedure.
Steps
- Remove the single (M2x2) screw to release the optical drive from the disk-drive cage.
- Slide the optical drive out of the disk-drive cage.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\