- Notes, cautions, and warnings
- Views of OptiPlex Small Form Factor 7010
- Set up your computer
- Specifications of OptiPlex Small Form Factor 7010
- Dimensions and weight
- Processor
- Chipset
- Operating system
- Memory
- External ports
- Internal slots
- Ethernet
- Wireless module
- Audio
- Storage
- Power ratings
- GPU—Integrated
- External display support (GPU—Integrated)
- GPU—Discrete
- External display support (GPU—Discrete)
- Hardware security
- Environmental
- Regulatory compliance
- Operating and storage environment
- Working inside your computer
- Removing and installing side cover
- Removing and installing coin-cell battery
- Removing and installing Customer Replaceable Units (CRUs)
- Removing and installing Field Replaceable Units (FRUs)
- Software
- BIOS Setup
- Troubleshooting
- Getting help and contacting Dell
OptiPlex Small Form Factor 7010 Owner's Manual
Removing and installing Field Replaceable Units (FRUs)
The replaceable components in this chapter are Field Replaceable Units (FRUs).
CAUTION: The information in this removing and installing FRU's section is intended for authorized service technicians only.
CAUTION:To avoid any potential damage to the component or loss of data, ensure that an authorized service technician replaces the Field Replaceable Units (FRUs).
CAUTION:Dell Technologies recommends that this set of repairs, if needed, to be conducted by trained technical repair specialists.
CAUTION: As a reminder, your warranty does not cover damages that may occur during FRU repairs that are not authorized by Dell Technologies.
NOTE:The images in this document may differ from your computer depending on the configuration you ordered.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\