Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

OptiPlex Small Form Factor 7010 Owner's Manual

Installing the wireless card

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the location of the wireless card and provides a visual representation of the installation procedure.

Installing the wireless card

Steps

  1. Connect the antenna cables to the wireless card.
    The following table provides the antenna-cable color scheme for the wireless card of your computer.
    Table 1. Antenna-cable color scheme The following table provides the Antenna-cable color scheme
    CONNECTORS ON THE WIRELESS CARD ANTENNA-CABLE COLOR
    Main (white triangle) White
    Auxiliary (black triangle) Black
  2. Slide and place the wireless-card bracket on the wireless card.
  3. Align the notch on the wireless card with the tab on the wireless-card slot.
  4. Slide the wireless card at an angle into the wireless-card slot.
  5. Replace the screw (M2x3.5) to secure the wireless card to the system board.

Next steps

  1. Install the disk-drive cage.
  2. Install the 3.5-inch hard drive if applicable.
  3. Install the 2.5-inch hard drive if applicable.
  4. Install the front bezel.
  5. Install the side cover.
  6. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\