- Notes, cautions, and warnings
- Views of OptiPlex Small Form Factor 7010
- Set up your computer
- Specifications of OptiPlex Small Form Factor 7010
- Dimensions and weight
- Processor
- Chipset
- Operating system
- Memory
- External ports
- Internal slots
- Ethernet
- Wireless module
- Audio
- Storage
- Power ratings
- GPU—Integrated
- External display support (GPU—Integrated)
- GPU—Discrete
- External display support (GPU—Discrete)
- Hardware security
- Environmental
- Regulatory compliance
- Operating and storage environment
- Working inside your computer
- Removing and installing side cover
- Removing and installing coin-cell battery
- Removing and installing Customer Replaceable Units (CRUs)
- Removing and installing Field Replaceable Units (FRUs)
- Software
- BIOS Setup
- Troubleshooting
- Getting help and contacting Dell
OptiPlex Small Form Factor 7010 Owner's Manual
Installing the internal antenna kit
CAUTION:The information in this section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the internal antenna kit and provides a visual representation of the installation procedure.
Steps
- Remove the protection mylars from the internal antennas.
- Insert the antennas into the slots on the chassis.
The antennas should be installed on the appropriate slots on the chassis. The following table provides guidance on the correct installation method.
Table 1. Antenna-cable color Scheme The following table provides the Antenna-cable color scheme CHASSIS LABEL ANTENNA-CABLE COLOR ANT-W White ANT-B Black - Replace the two screws (M3x3) that secure the internal antennas to the chassis.
- Route the internal-antenna cable through the routing guides on the chassis.
Next steps
- Install the wireless card if applicable.
- Install the disk-drive cage.
- Install the 3.5-inch hard drive if applicable.
- Install the 2.5-inch hard drive if applicable.
- Install the front bezel.
- Install the side cover.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\