OptiPlex Small Form Factor 7010 Owner's Manual

PDF

Screw list

NOTE:When removing screws from a component, it is recommended to note the screw type, and the quantity of screws, and then place them in a screw storage box. This is to ensure that the correct number of screws and correct screw type is restored when the component is replaced.

NOTE:Some computers have magnetic surfaces. Ensure that the screws are not left attached to such surfaces when replacing a component.

NOTE:Screw color may vary with the configuration ordered.

Table 1. Screw listThe following table provides the different screws that are used in your OptiPlex Small Form Factor 7010.
Component	Screw type	Quantity	Screw image
M.2 2230/M.2 2280 Solid-state drive	M2x3.5	1
Hard-drive and optical-drive supporting bracket	#6-32	1
Optical-drive supporting bracket	M2x2	1
2.5-inch Hard-drive	M3x3.5	4
3.5-inch Hard-drive	#6-32	4
Serial/VGA module	M2x5	2
DP/HDMI/Type-C module	M3x3	2
SD-card reader	M3x5	1
WLAN card	M2x3	1
Processor-fan and heat-sink assembly	Captive	4
Voltage regulator heat-sink	Captive	4
Power-supply unit	#6-32	3
System board	#6-32	5