Alienware 15 R3 Service Manual

Procedure

  1. Using the pull-tab, disconnect the hard-drive cable from the system board.
  2. Remove the three screws (M2.5x8) that secure the hard-drive assembly to the computer base.
  3. Lift the hard-drive assembly along with its cable off the computer base. Image: Removing the hard drive
  4. Remove the four screws (M3x3) that secure the hard-drive bracket to the hard-drive assembly.
  5. Lift the hard-drive bracket off the hard-drive assembly. Image: Removing hard-drive bracket
  6. Disconnect the interposer from the hard drive.Image: Disconnecting the interposer

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\