Alienware 15 R3 Service Manual

Procedure

  1. Align the screw holes on the display hinges with the screw holes on the display back-cover.
  2. Replace the 14 screws (M2.5x3) that secure the display hinges to the display back-cover .
  3. Route the antenna cables, display-board cable, and display cable through the routing guides on the display back-cover .
  4. Turn the display assembly over.
  5. Place the hinge caps on the display hinges and press down to snap them into place.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\