Alienware 15 R3 Service Manual

Procedure

  1. Place the display assembly on a clean and flat surface.
  2. Connect the tron-light cables to the logo board.
  3. Connect the logo-board cable to the logo board.
  4. Slide the alien head cable into the logo board and close the latch to secure the cable.
  5. Carefully turn the display bezel over.
  6. Align the display bezel with the display back-cover and gently snap the display bezel into place.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\