Alienware 15 R3 Service Manual

Prerequisites

  1. Remove the base cover.
  2. Remove the wireless card.
  3. Follow the procedure from step 1 to step 3 in "Removing the hard drive".
  4. Remove the solid-state drive.
  5. Remove the rear-I/O cover.
  6. Remove the computer base.
  7. Remove the battery.
  8. Remove the memory modules.
  9. Follow the procedure from step 1 to step 17 in “ Removing the system board”.
  10. Remove the display assembly.
  11. Remove the display bezel.
  12. Remove the camera.
  13. Remove the display panel.
  14. Remove the camera cable.
  15. Remove the display hinges.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\