Alienware 15 R3 Service Manual

Procedure

  1. Align the screw holes on the computer base with the screw holes on the palm-rest assembly.
  2. Replace the 11 screws (M2.5x8) that secure the computer base to the palm-rest assembly.
  3. Replace the two screws (M2x3) that secure the computer base to the palm-rest assembly.
  4. Connect the tron-light cables to the system board.
  5. Route the marco-keys cable, keyboard cable, and keyboard-backlight cable through the routing guides on the computer base.
  6. Slide the macro-keys cable, keyboard cable, and keyboard-backlight cable into their respective connectors on system board and close the latches to secure the cables.
  7. Route the antenna cables through the routing guides on the computer base.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\