Dell Lasso Version 4.7.3 User's Guide

Manually Collecting Data For Brocade or PowerConnect B-Series And M8428K Switches

To collect data for Brocade or PowerConnect B-Series and M8428K manually:

Log in to Brocade or Power Connect B-Series and M8428K FCoE switches through SSH/Telnet.
Run the command supportShow to display FC information.
To display CEE information, run the command show tech-support.
If the command fails, in the case of older switch firmware, then run the following commands:
- show running-config
- show startup-config
- show system
- show version
- show vlan brief
- show media
- show lldp
- show lldp neighbors
- show interface
- show interface switchport
- show port-channel
- show mac-address-table
- show spanning-tree brief
- show spanning-tree
- show cee maps
- show vlan fcoe
- show ip interface brief
- show interface switchport
- show lldp statictics
- show port-channel summary
- show mac-address-table count
- show spanning-tree mst brief
- show qos rcv-queue multicast all
- show qos interface all
- show fcoe-map
- fos switchshow
- fos cfgshow
- fos zoneshow
- chassisshow
Capture the console output .
- NOTE: On SAN having many PowerConnect B-Series switches, you need to increase the time out value. By default, time out value for these switches is 12 minutes (in milliseconds). This value ( powerconnectb-series.timeout) can be modified in the file ESC.properties located in the Lasso install directory.