Dell Lasso Version 4.7.3 User's Guide

Manually Collecting Data For Ethernet and Nexus Switches

To collect information for switches:

Connect to the switch using Telnet:
```
telnet -f %USERPROFILE%\Dell\Lasso\results\hostname.txt hostname
```
- NOTE: On Windows 2000, use HyperTerminal and manually capture the telnet session.
After logging in, enter the command relevant to the type of switch.
- PowerConnect B-Series, Brocade B-Series, and M8428K:
  - To run the commands, see List Of Commands For PowerConnect B-Series, Brocade B-Series, and M8428K
- PowerConnect Ethernet:
  - To run the commands, see List Of Commands For PowerConnect Ethernet
- Cisco Ethernet:
  - terminal length 0
  - To run the commands, see List Of Commands For Cisco Ethernet
- Cisco Nexus:
  - terminal length 0
  - show startup-config
  - To run the sub-commands, see List Of Commands For Cisco Nexus
- Force 10 Switches
  - terminal length 0
  - To run the commands, see List Of Commands For Force 10 Switches .
- Dell Networking
  - If the firmware version is 6.0 and above, to run the commands, see List Of Commands For PowerConnect Ethernet
  - If the firmware version is 9.4 and above, to run the commands, see List Of Commands For Force 10 Switches