Dell Lasso Version 4.7.3 User's Guide

Manually Collecting Data For Cisco Ethernet Device

To collect for Cisco Ethernet manually:

Log in to Cisco Ethernet switch through SSH/Telnet.
Run the following command to enter the required mode:
- Exec — enable
- Configuration — config
Run the following commands
- show running
- show vlan
- show flowcontrol
- show system mtu
- show vlan mtu
- show switch stack-ports
- show spanning-tree
- show interfaces status
- show mac address-table
- show version
- show env all
- show etherchannel
- show arp
- show switch
- show storm-control
- show interfaces mtu
- show switch stack-ring speed
- show switch stack-ring activity
- show etherchannel summary
- show environment
- show module
- show inventory
- show interfaces trunk
For CEE information, run the command show tech-support .
Capture the console output
- NOTE: On a SAN consisting of many Cisco Ethernet switches, you may need to increase the time out value. By default, the time out value for these switches is 3 minutes (in milliseconds). This value ( ciscoethernet.timeout) can be modified in the file ESC.properties located in the Lasso install directory.