Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell Lasso Version 4.7.3 User's Guide

PDF

Manually Collecting Data For PowerConnect Ethernet and Dell Networking Switches

To collect information for PowerConnect Ethernet manually:
  1. Log in to Power Connect Ethernet switch through SSH/Telnet.
  2. Run the command show tech-support to display CEE information. If the command fails, in the case of older switch firmware, then run the following commands
    • show running
    • show vlan
    • show spanning-tree
    • show interfaces configuration
    • show interfaces status
    • show interface port-channel
    • show system id
    • show stack-port
    • show storm-control
    • show storm-control all
    • show system
    • show system flowcontrol
    • show version
    • show switch
    • show arp
    • show bridge address-table
    • show mac address-table
    • show port-aggregator vlan summary
    • show port-aggregator port summary
    • show switch stack-ports
    • show switch stack-ports counter
    • show switch stack-ports diag
    • show nsf
    • show switch stack-standby
    • show checkpoint statistics
    • Show Slot
    • Show tacacs
    • Show spanning-tree active
    • Show spanning-tree blockedports
    • Show lldp dcbx interface all
    • Show lldp interface all
    • Show lldp tlv-select interface all
    • Show lldp remote-device all
    • show classofservice dot1p-mapping
    • show classofservice traffic-class-group
    • show interfaces traffic-class-group
    • show interfaces priority-flow-control
    • show interfaces tengigabitethernet <InterfaceName> priority-flow-control
    • show interfaces counters tengigabitethernet <InterfaceName>
    • show lldp tlv-select interface tengigabitethernet <InterfaceName>
    • show lldp interface tengigabitethernet <InterfaceName>
    • show lldp dcbx interface tengigabitethernet <Interface Name> detail
    • show interfaces transceiver properties
    • show isdp neighbors
  3. Capture the console output
    • NOTE: On SAN having many PowerConnect Ethernet switches, you may need to increase the time out value. By default, time out value for these switches is 3 minutes (in milliseconds). This value ( powerconnectethernet.timeout) can be modified in the file ESC.properties located in the Lasso install directory.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\