- Notes, cautions, and warnings
- Introduction
- Installing And Uninstalling Lasso
- Security
- Using Lasso
- Prerequisites For Data Collection
- Running Lasso
- Lasso GUI —
Fields And Descriptions
- Welcome to Lasso
- Your Company Information
- Your Company Contacts
- Your Hardware Environment
- Your Hardware Environment: Storage Arrays
- Your Hardware Environment: Fibre Channel Switches
- Your Hardware Environment: Ethernet Switches
- Your Hardware Environment: Hosts
- Your Hardware Environment: Enclosures
- Your Hardware Environment: Enclosure Modules
- Your Hardware Environment: Management & Monitoring Software
- Your Hardware Environment: Wireless Controllers
- Device Collection
- Collection Process for Dell Compellent Devices
- Upload
- Confirmation
- Log Files
- Generated File Formats
- Viewing Reports
- Manual Collection
- Manually Collecting Data For Storage Arrays
- Manually Collecting Data For Attached Hosts
- Manually Collecting
Data For Ethernet and Nexus Switches
- Manually Collecting Data For Cisco Ethernet Device
- Manually Collecting Data For Cisco Nexus Device
- Manually Collecting Data For Brocade or PowerConnect B-Series And M8428K Switches
- Manually Collecting Data For PowerConnect Ethernet and Dell Networking Switches
- Manually Collecting Data For Force 10 and Dell Networking Switches
- Manually Collecting Data For Fibre Channel Switches
- Manually Collecting Data For Enclosures — M1000e
- Manually Collecting Data For Enclosure — VRTX
- Manually Collecting Data For Enclosure — PowerEdge FX2
- Manually Collecting Data For HITKIT Appliance Under VRTX
- Manually Collecting Data For SAN HQ DEVICE
- Manually Collecting Data For SCVMM 2008 and 2012
- Manually Collecting Data For PowerConnect Controller
- Manually Collecting Integrated Server Information Within VRTX
- Collecting Data Using CLI
- Troubleshooting
- Troubleshooting EMC Package Installation
- Troubleshooting Unix Host Collection
- Troubleshooting MD Series
- Troubleshooting Compellent Collections for SCOC Versions Prior to 6.6.x
- Troubleshooting Compellent Collections for SCOS Versions Later than 6.6.x
- Troubleshooting EqualLogic
- Troubleshooting Storage Processor
- Troubleshooting Switches
- Troubleshooting Ethernet Switch
- Troubleshooting Unix
- Troubleshooting Windows
- Troubleshooting Enclosures
- Troubleshooting HITKIT Collection
- Troubleshooting SAN HQ Device
- Troubleshooting PowerVault FluidFS NAS Collection
- Troubleshooting EqualLogic FluidFS NAS Collection
- Troubleshooting Celerra Collection
- Troubleshooting VMware Collection
- Troubleshooting PowerConnect Controller
- Troubleshooting Lasso Run As System Account
- Error Codes
- Use Case Scenario
- Frequently Asked Questions
- License
Dell Lasso Version 4.7.3 User's Guide
Manually Collecting Data For McDataBlade Device
The following
sub-commands are included in the
show all command.
In some older switch firmware, the
show all command
may not work. In this case Lasso attempts a manual collection using
these commands.
- show about
- show chassis
- show donor
- show interface
- show mem
- show perf
- show setup mfg
- show setup radius
- show setup services
- show setup snmp
- show setup system
- show version
- show config port
- show config switch
- show config zoning
- show fabric
- show topology
- show switch
- show domains
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\