Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

ip ecmp-group

Enable and specify the maximum number of ecmp that the L3 CAM hold for a route, By default, when maximum paths are not configured, the CAM can hold a maximum of 16 ecmp per route.

Syntax

ip ecmp-group {maximum-paths | { number} {path-fallback}

To negate a command, use the no ip ecmp-group maximum-paths command.

Parameters

maximum-paths	Specify the maximum number of ECMP for a route. The range is 2 to 64.
path-fallback	Use the keywords `path-fallback` to enable this feature. If you enable the feature, re-enter this keyword to disable the feature.

Defaults

16

Command Modes

CONFIGURATION

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.2(0.0)	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

You must save the new ECMP settings to the startup-config ( write-mem) then reload the system for the new settings to take effect.

Related Commands

show ip cam stack-unit — Display content-addressable memory (CAM) entries.