Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

show running-config

Displays the current configuration and display changes from the default values.

Syntax

show running-config [ entity] [configured] [status]

Parameters

entity

(OPTIONAL) To display that entity’s current (non-default) configuration, enter one of the following keywords:

NOTE: If you did not configure anything for that entity, nothing displays and the prompt returns.

`boot`	for the current boot configuration
`ftp`	for the current FTP configuration
`igmp`	for the current IGMP configuration
`interface`	for the current interface configuration
`line`	for the current line configuration
`lldp`	for the current lldp configuration
`logging`	for the current logging configuration
`management-route`	for the current Management port forwarding configuration
`monitor`	for the current Monitor configuration
`snmp`	for the current SNMP configuration
`uplink-state-group`	for the uplink state group configuration
`users`	for the current users configuration

configured

(OPTIONAL) Enter the keyword configured to display line card interfaces with non-default configurations only.

status

(OPTIONAL) Enter the keyword status to display the checksum for the running configuration and the start-up configuration.

Command Modes

EXEC Privilege

Supported Modes

All Modes

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.4(0.0)	Supported on the FN I/O aggregator.
8.3.17.0	Supported on the M I/O Aggregator.

Example

Dell#show running-config
                                             Current Configuration ...
                                             ! Version 9-4(0-180)
                                             !
                                             boot system stack-unit 0 primary tftp://10.11.8.12/dv-ci-stomp-tc-1-a1
                                             !
                                             redundancy auto-synchronize full
                                             !
                                             hostname Dell
                                             ...

Example

Dell#show running-config status
                                             
                                             running-config bytes 5063, checksum 0xF6F801AC
                                             startup-config bytes 4835, checksum 0x764D3787
                                             Dell#

Example

Dell#sh running-config interface vlan
                                             !
                                             interface Vlan 1
                                             ip address dhcp
                                             mtu 2500
                                             no shutdown
                                             Dell#

Usage Information

The status option allows you to display the size and checksum of the running configuration and the startup configuration.