Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

match ip vlan

Uses a VLAN as the match criterion for an L3 class map.

Syntax

match ip vlan vlan-id

To remove VLAN as the match criterion, use the no match ip vlan vlan-id command.

Parameters

vlan vlan-id

Enter the keyword vlan and then the ID of the VLAN. The range is from 1 to 4094.

Defaults

none

Command Modes

CONF-CLASS-MAP

Supported Modes

Full–Switch

Command History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.4(0.0)	Introduced on the MXL switch.

Usage Information

To access this command, enter the class-map command. After the class map is identified, you can configure the match criteria.

Use this command to match an IP class-map against a single VLAN ID .

Related Commands

class-map — identifies the class map.