Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

vlan bridge-priority

Set the PVST+ bridge-priority for a VLAN or a set of VLANs.

Syntax

vlan vlan-id bridge-priority value

To return to the default value, use the no vlan bridge-priority command.

Parameters

vlan vlan-range	Enter the keyword `vlan` then the VLAN numbers. The range is from 1 to 4094.
bridge-priority value	Enter the keywords `bridge-priority` then the bridge priority value in increments of 4096. The range is from 0 to 61440. The default is 32768.

Defaults

32768

Command Modes

CONFIGURATION (conf-pvst)

Supported Modes

Full—Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
8.3.16.1	Introduced on the MXL 10/40GbE Switch IO Module.

Related Commands

vlan forward-delay — changes the time interval before the system transitions to the Forwarding state.

vlan hello-time — change the time interval between BPDUs.

vlan max-age — changes the time interval before PVST+ refreshes.

show spanning-tree pvst — displays the PVST+ configuration.