Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

keepalive

Send keepalive packets periodically to keep an interface alive when it is not transmitting data.

Syntax

keepalive [ seconds]

To stop sending keepalive packets, use the no keepalive command.

Parameters

seconds

(OPTIONAL) For interfaces with PPP encapsulation enabled, enter the number of seconds between keepalive packets. The range is from 0 to 23767. The default is 10 seconds.

Defaults

Enabled.

Command Modes

INTERFACE

Supported Modes

All Modes

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.4(0.0)	Supported on the FN I/O Aggregator.
9.2(0.0)	Supported on the M I/O Aggregator.
8.3.16.1	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

When you configure keepalive, the system sends a self-addressed packet out of the configured interface to verify that the far end of a WAN link is up. When you configure no keepalive, the system does not send keepalive packets and so the local end of a WAN link remains up even if the remote end is down.