Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

qos-policy-output

Create a QoS output policy.

Syntax

qos-policy-output qos-policy-name

To remove an existing output QoS policy, use the no qos-policy-output qos-policy-name command.

Parameters

qos-policy-name

Enter your output QoS policy name in character format (32 characters maximum).

Defaults

none

Command Modes

CONFIGURATION

Supported Modes

Programmable-Mux (PMUX)

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.4(0.0)	Supported on the FN I/O Aggregator.
9.2(0.0)	Introduced on the M I/O Aggregator.
8.3.16.1	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

To specify the name of the output QoS policy, use this command. After the output policy is specified, rate-limit, bandwidth-percentage, and WRED can be defined. This command enables Qos-Policy-Output Configuration mode — (conf-qos-policy-out).

Related Commands

bandwidth-percentage — assigns weight to the class/queue percentage.