Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

neighbor remote-as

Create and specify the remote peer to the BGP neighbor.

Syntax

neighbor { ip-address | peer-group-name} remote-as number

To delete a remote AS entry, use the no neighbor { ip-address | peer-group-name} remote-as number command.

Parameters

ip-address	Enter the IP address of the neighbor to enter the remote AS in its routing table.
peer-group-name	Enter the name of the peer group to enter the remote AS into routing tables of all routers within the peer group.
number	Enter a number of the AS. The range is from 0 to 65535 (2 byte) or from 1 to 4294967295 (4 byte).

Defaults

Not configured.

Command Modes

ROUTER BGP

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.2(0.0)	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

To accept 4-byte formats before entering a 4 byte AS Number, configure your system. If the number parameter is the same as the AS number used in the router bgp command, the remote AS entry in the neighbor is considered an internal BGP peer entry.

This command creates a peer and the newly created peer is disabled (Shutdown).

Related Commands

router bgp — enters ROUTER BGP mode and configures routes in an AS.

bgp four-octet-as-support — enables 4-byte support for the BGP process.