Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

neighbor next-hop-self

Allows you to configure the router as the next hop for a BGP neighbor.

Syntax

neighbor { ipv6-address | peer-group-name} next-hop-self

To return to the default setting, use the no neighbor { ipv6-address | peer-group-name} next-hop-self command.

Parameters

ipv6-address	Enter the IPv6 address in the x:x:x:x::x format. NOTE: The :: notation specifies successive hexadecimal fields of zeros.
peer-group-name	(OPTIONAL) Enter the name of the peer group.

Defaults

Disabled.

Command Modes

ROUTER BGPV6-ADDRESS FAMILY

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.2(0.0)	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

If you configure the set ipv6 next-hop command in ROUTE-MAP mode, its configuration takes precedence over the neighbor next-hop-self command.