Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

ipv6 neighbor

Configure a static entry in the IPv6 neighbor discovery.

Syntax

ipv6 neighbor { ipv6-address} {interface interface} { hardware_address}

To remove a static IPv6 entry from the IPv6 neighbor discovery, use the no ipv6 neighbor { ipv6-address} {interface interface} command.

Parameters

ipv6-address	Enter the IPv6 address of the neighbor in the x:x:x:x::x format. NOTE: The :: notation specifies successive hexadecimal fields of zero.
interface interface	Enter the keyword `interface` then the interface type and slot/port or number information: For a Fast Ethernet interface, enter the keyword `fastEthernet` then the slot/port information. For a Port Channel interface, enter the keywords `port-channel` then a number. For a 10-Gigabit Ethernet interface, enter the keyword `TenGigabitEthernet` then the slot/port information.
hardware_address	Enter a 48-bit hardware MAC address in nn:nn:nn:nn:nn:nn format.

Defaults

none

Command Modes

CONFIGURATION

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.2(0.0)	Introduced on the MXL 10/40GbE Switch IO Module.