Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

private-vlan mode

Set PVLAN mode of the selected VLAN to community, isolated, or primary.

Syntax

[no] private-vlan mode {community | isolated | primary}

To remove the PVLAN configuration, use the no private-vlan mode {community | isolated | primary} command syntax.

Parameters

community	Enter the keyword `community` to set the VLAN as a community VLAN.
isolated	Enter the keyword `isolated` to configure the VLAN as an isolated VLAN.
primary	Enter the keyword `primary` to configure the VLAN as a primary VLAN.

Defaults

none

Command Modes

INTERFACE VLAN

Supported Modes

Full—Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
8.3.16.1	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

The VLAN:

can be in only one mode, either community, isolated, or primary.
mode ode to community or isolated even before associating it to a primary VLAN. This secondary VLAN continues to work normally as a normal VLAN even though it is not associated to a primary VLAN. (A syslog message indicates this.)
must not have a port in it when VLAN mode is being set.

Only ports (and port channels) configured as promiscuous, host, or PVLAN trunk ports (as previously described) can be added to the PVLAN. No other regular ports can be added to the PVLAN.

After using this command to configure a VLAN as a primary VLAN, use the private-vlan mapping secondary-vlan command to map secondary VLANs to this VLAN.

Related Commands

private-vlan mapping secondary-vlan — maps secondary VLANs to the selected primary VLAN.

show interfaces private-vlan — displays the type and status of the PVLAN interfaces.

show vlan private-vlan — displays the PVLANs and/or interfaces that are part of a PVLAN.

show vlan private-vlan mapping — displays the primary-secondary VLAN mapping.

switchport mode private-vlan — sets PVLAN mode of the selected port.