Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

ip pim join-filter

Permit or deny PIM Join/Prune messages on an interface using an extended IP access list. This command prevents the PIM-SM router from creating state based on multicast source and/or group.

Syntax

ip pim join-filter ext-access-list {in | out}

To remove the access list, use the no ip pim join-filter ext-access-list {in | out} command.

Parameters

ext-access-list	Enter the name of an extended access list.
in	Enter this keyword to apply the access list to inbound traffic.
out	Enter this keyword to apply the access list to outbound traffic.

Defaults

none

Command Modes

INTERFACE

Supported Modes

Full—Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.2(0.0)	Introduced on the MXL 10/40GbE Switch IO Module.

Example

Dell(conf)# ip access-list extended iptv-channels
                                             Dell(config-ext-nacl)# permit ip 10.1.2.3/24 225.1.1.0/24
                                             Dell(config-ext-nacl)# permit ip any 232.1.1.0/24
                                             Dell(config-ext-nacl)# permit ip 100.1.1.0/16 any
                                             Dell(config-if-te-1/1)# ip pim join-filter iptv-channels in
                                             Dell(config-if-te-1/1)# ip pim join-filter iptv-channels out

Related Commands

ip access-list extended — configure an access list based on IP addresses or protocols.