Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

uplink-state-group

Create an uplink-state group and enable the tracking of upstream links on a switch/ router.

Syntax

uplink-state-group group-id

To delete an uplink-state group, enter the no uplink-state-group group-id command.

Parameters

group-id

Enter the ID number of an uplink-state group. The range is from 1 to 16.

Defaults

none

Command Modes

CONFIGURATION

Supported Modes

Programmable-Mux (PMUX)

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.4(0.0)	Supported on the FN I/O Aggregator.
9.2(0.0)	Supported on the M I/O Aggregator.

Usage Information

After you enter the command, to assign upstream and downstream interfaces to the group, enter Uplink-State-Group Configuration mode.

An uplink-state group is considered to be operationally up if at least one upstream interface in the group is in the Link-Up state.

An uplink-state group is considered to be operationally down if no upstream interfaces in the group are in the Link-Up state. No uplink-state tracking is performed when a group is disabled or in an operationally down state.

To disable upstream-link tracking without deleting the uplink-state group, use the no enable command in uplink-state-group configuration mode.

Example

Dell(conf)#uplink-state-group 16
                                             Dell(conf)#
                                             02:23:17: %RPM0-P:CP %IFMGR-5-ASTATE_UP: Changed uplink state group Admin state to up: Group 16

Related Commands

show running-config uplink-state-group — displays the current configuration of one or more uplink-state groups.
show uplink-state-group — displays the status information on a specified uplink-state group or all groups.