Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

ipv6 ospf cost

Explicitly specify the cost of sending a packet on an interface.

Syntax

ipv6 ospf interface-cost

Parameters

interface-cost

Enter a unsigned integer value expressed as the link-state metric. The range is from 1 to 65535.

Defaults

Default cost based on the bandwidth.

Command Modes

INTERFACE

Supported Modes

Full—Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.2(0.0)	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

In general, the path cost is calculated as:

10^8 / bandwidth

Using this formula, the default path cost is calculated as:

TenGigabitEthernet—Default cost is 1
Ethernet—Default cost is 10