Dell PowerEdge T550 Installation and Service Manual

PDF

Installing the BOSS S2 card carrier

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure that is listed in Before working inside your system.
  3. If installed, remove the front bezel.

Steps

  1. Press the release clip and pull the BOSS S2 card carrier blank out of the system.
    Figure 1. Removing the BOSS S2 card carrier blank
    This image shows removing the BOSS S2 card carrier blank.
  2. Align and push the BOSS S2 card carrier into the slot in the BOSS S2 module.
  3. Close the release latch to secure the BOSS S2 card carrier.
    Figure 2. Installing the BOSS S2 card carrier
    This image shows removing the BOSS S2 card carrier.

Next steps

  1. Install the air shroud.
  2. If removed, install the front bezel.
  3. Follow the procedure that is listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\