Dell PowerEdge T550 Installation and Service Manual

PDF

Installing the serial COM port

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure that is listed in Before working inside your system.
  3. Remove the air shroud.

Steps

  1. Open the blue latch and remove the filler bracket from the system.
  2. Slide the serial COM port and close the blue latch, until it snaps into place.
    Figure 1. Installing the serial COM port
    This image shows how to Install the Serial COM port.

Next steps

  1. Connect the cable to serial COM port.
  2. Install the air shroud.
  3. Follow the procedure listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\