Dell PowerEdge T550 Installation and Service Manual

PDF

Installing the internal USB module

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure that is listed in Before working inside your system.
  3. Remove the air shroud.

Steps

  1. Locate the internal USB connector on the system board.
    NOTE: For information on the exact location of internal USB on system board, see System board jumpers and connector section.
  2. Align internal USB module with the connector on the system board.
  3. Press the internal USB module until firmly seated on the system board.
    Figure 1. Installing the internal USB module
    This image shows installing the internal USB module.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\