Dell PowerEdge T550 Installation and Service Manual

PDF

Removing the serial COM port

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure that is listed in Before working inside your system.
  3. Remove the air shroud.
  4. Disconnect the cable connected to the serial COM port.

Steps

  1. Open the blue latch and slide the serial COM port out of the system.
    Figure 1. Removing the serial COM port
    This image shows how to remove the serial COM port.
  2. Install the filler bracket if not replacing the serial COM port.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\