Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell PowerEdge T550 Installation and Service Manual

PDF

Installing the power interposer board

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure that is listed in Before working inside your system.
  3. Remove the air shroud.
  4. Remove the PSU.

Steps

  1. Align the screw holes on the power interposer board (PIB) with the holes on the system.
  2. Using the Phillips 2 screwdriver, secure the PIB to the system using the screws.
  3. Connect all the disconnected power cables to the PIB.
    Figure 1. Installing the power interposer board
    This image shows installing the power interposer board.

Next steps

  1. Install the PSUs.
  2. Install the air shroud.
  3. Follow the procedure listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\