- Notes, cautions, and warnings
- Introduction
- Linux
- Overview—deployment steps and options
- Preparation for deployment
- Download installation packages—Linux
- Deploying PowerFlex with SELinux
- Prepare server operating systems for support of large-scale systems (up to 2048 SDCs)
- Prepare the DAX devices
- Install and configure the PowerFlex Gateway
- Install PowerFlex Gateway on Linux
- Install PowerFlex Gateway on Windows
- Configure PowerFlex Gateway properties
- Advanced and optional PowerFlex Gateway tasks
- Install the PowerFlex Gateway without assigning an admin password
- Reset PowerFlex Gateway password
- Store Tomcat's keystore password in the lockbox
- PowerFlex Gateway installation with a custom Java configuration
- Install Java on SUSE 12 servers
- Certificate management for PowerFlex Gateway
- Using SSH authentication on the PowerFlex Gateway
- Preparation tasks for SLES, Oracle Linux and Ubuntu
- Prepare the CSV file
- Clean the PowerFlex VMware environment
- Deploying PowerFlex using a non-root user
- Configure the OpenStack Nova Compute service
- Deploy PowerFlex
- Installation wizard
- Customizable installation using CSV file—hyper-converged system
- Customizable installation using CSV file—two-layer system
- Log in and upload installation packages
- Upload the CSV file
- Start the customized installation
- Complete the customized installation—two-layer system backend
- Install SDC on frontend servers
- Install the PowerFlex presentation server
- SDC (scini) driver configuration for SELinux
- Add components to a PowerFlex system—Linux
- VMware ESXi
- Overview—deployment steps
- Preparation for deployment
- Deploy PowerFlex using the vSphere PowerFlex plug-in
- Manually deploy PowerFlex on ESXi servers
- Manual Deployment of VxFlex OS on ESXi Servers
- Deploying the PowerFlex storage virtual machine (SVM)
- Manually install PowerFlex components on the SVMs
- Register the vSphere PowerFlex plug-in
- Install SDC on an ESXi server using the vSphere PowerFlex plug-in
- Install the SDC on an ESXi-based server and connect it to PowerFlex using esxcli
- Manually remove a VIB file from an ESXi host
- Add components to a PowerFlex system—ESXi
- PowerFlex Installer REST API
- PowerFlex VASA
- Post-deployment tasks
Deploy Dell PowerFlex v3.6.x
Customizable installation using CSV file—hyper-converged system
This section describes how to use the PowerFlex Installer and a CSV topology file to get a fully customized hyper-converged PowerFlex system up and running.
Prerequisites
Ensure that you have performed all the preparation tasks before using the PowerFlex Installer, and in particular, that you have prepared the CSV file.
About this task
The PowerFlex Installer guides you through the following tasks:
Steps
- Setting up the installation.
-
Running the installation.
After installation is complete, a number of post-installation tasks must be performed, including PowerFlex presentation server installation (required for the PowerFlex GUI), configuration and license activation.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\