Dell PowerEdge FN I/O Module Configuration Guide 9.10(0.0)

To apply a filter to routes in open shortest path first (OSPF), use the following commands.

• Enter OSPF mode. CONFIGURATION mode router ospf
• Apply a configured prefix list to incoming routes. You can specify an interface. If you enter the name of a non-existent prefix list, all routes are forwarded. CONFIG-ROUTER-OSPF mode distribute-list prefix-list-name in [ interface]
• Apply a configured prefix list to incoming routes. You can specify which type of routes are affected. If you enter the name of a non-existent prefix list, all routes are forwarded. CONFIG-ROUTER-OSPF mode distribute-list prefix-list-name out [connected | rip | static]

Dell(conf-router_ospf)#show config
                                 !
                                 router ospf 34
                                 network 10.2.1.1 255.255.255.255 area 0.0.0.1
                                 distribute-list prefix awe in
                                 Dell(conf-router_ospf)#